Zoning is used with a dielectric antenna in order to

(a) permit pin-point focusing
(b) reduce the bulk of the lens
(c) increase the bandwidth of the lens
(d) correct the curvature of the wave front from a horn that is too short

Ans: B

Comments

Post a Comment

Popular posts from this blog

Recently Asked Electrostatics Interview Questions And Answers

Image
1. Explain The Concept Of Density ? One of the properties characteristic of every material is its density. We observe that a small piece of one material may be heavier than a much large piece of another material. The mass per unit volume of a substance is called its density p = m/V Units of density are determined by dividing the chosen unit of mass by the unit of volume, as kilogram per cubic meter, gram per cubic centimeter, or slug per cubic foot. It is sometimes helpful to use another quantity called weight-density, or weight per unit volume:                                   D = W/V Since W = mg, we have a simple relation between density and weight-density: D = ?g Weight-density is commonly used when we are concerned with effects depending upon force, while density is used when mass is to be considered. Solids and liquids are only slightly compresses by even large stresses; hence their densities are...
Read more

50 TOP Irrigation Engineering Interview Questions & Answers pdf

Here are top 50 Irrigation Engineering Interview questions and answers are given just below to them. These sample Irrigation Engineering questions are framed by experts. who train for Learn Irrigation Engineering Online to give you an idea of Irrigation Engineering questions which may be asked in interview. We have taken full care to give correct answers for all the questions. Do comment your thoughts. Happy Job Hunting! 1. Why Are Landscapes Irrigated? Simply stated, irrigation provides the water requirements for sustainability of plants when rainfall is not sufficient. Ornamentals: Trees and shrubs are irrigated frequently when grown in the nursery and when first planted so that their roots quickly grow out from the root ball and into the soil in the landscape. It is crucial that roots grow as quickly as possible so irrigation can cease. The best way to encourage rapid root growth is frequent light irrigation applied to the root ball after planting. Under ideal con...
Read more

Real Time Induction Motor Interview Questions And Answers

Image
1. How does the Induction motor work? (OR) Why does the Rotor rotate? When the 3 phase stator windings are fed by 3 phase supply, a magnetic flux of constant magnitude which is rotating at synchronous speed is set up. The flux passes through the air-gap and sweeps past the rotor surface  thus it cuts the rotor conductors. Due to the relative speed between the rotating flux and the stationary rotor conductors, an emf is induced in the stationary rotor conductors as per the Faraday's laws of electromagnetic induction. The frequency of the induced emf is the same as the supply frequency. Its magnitude is proportional to the relative velocity between the flux and the conductors. Its direction will be as per Fleming's right hand rule. Since the rotor conductors form a closed circuit the rotor current is produced. This current's direction will oppose the very cause producing it ( as per Len's law) Here the cause is the relative velocity between the rotating flux of the stator...
Read more